Use the below tool to find the right Auto Door for your Machine.
CNC Auto Door Configurator
CNC AutoDoor Finder
Find the right automatic door opener for your CNC machine.
Select the age of your machine, door arrangement and required stroke. The finder applies the motor-sizing rules automatically and shows the suitable CNC AutoDoor models.
Product selector
Find suitable CNC AutoDoor models
Enter the actual travel of the moving door panel, not the overall machine opening width.
This application remains eligible for the 180 kg motor range.
Your results
Suitable models
No standard model matches these inputs
The selected stroke falls outside the standard operating range after the motor-sizing rule is applied. CaPa Tec can check the machine and advise on the correct configuration.
*Motor rating is not the same as static door weight alone. Final selection must confirm the complete dynamic mass, door condition, clearances, control interface and safety requirements.
See CNC AutoDoor in action
Want to see how CNC AutoDoor works?
Watch real CNC AutoDoor installations, automatic door operation and safety demonstrations, and see how the system can form part of a robot or cobot machine-tending solution.
A small upgrade with a big operational impact
Make the machine door part of the automation.
CNC AutoDoor converts manual door handling into a controlled machine function, allowing the CNC machine to open and close the workspace for an operator, robot or cobot.
- Remove repetitive door handling from the operator
- Prepare an existing machine for robotic loading
- Reduce non-cutting time between cycles
- Integrate using open, close and position feedback signals
One range. Many machine doors.
Single, double and telescopic configurations.
The standard range covers stroke lengths up to 4,000 mm and motor ratings up to 700 kg. Systems are available for one door, two opposing doors or linked telescopic panels.
See it operate
Controlled movement, configured to the machine.
The controller completes a learn run during commissioning to measure the moving system and establish the door parameters. The final installation must be assessed as part of the complete CNC machine.
Watch more application & safety videos →Not sure which arrangement you have?
Send us the machine make, model and door measurements.
CaPa Tec can verify the application, recommend the correct CNC AutoDoor model and support installation and machine-interface requirements.